Generator Sales, Service, & Maintenance
East Coast Lumber is an authorized sales & service center for Generac. We offer various repair and maintenance services to keep your generator running properly and to give you peace of mind. In addition to repair services, we also offer annual tune-ups and yearly maintenance plans.
| ZONE |
Truck ONLY |
| Hampstead & East Hampstead |
$60 |
| Atkinson, Danville, Kingston, Sandown & Plaistow |
$70 |
| Chester, Derry, E. Kingston, Newton & Salem |
$80 |
| Brentwood, Fremont, Haverhill MA, Londonderry, Merrimac MA, Raymond & Windham |
$90 |
| with Trailer or Ramp Truck |
+$25 |
If you'd like to schedule
a delivery outside of these areas, please contact us.
*Our rates may vary with vehicle type and size required to safely transport your equipment. These prices are for reference only and are subject to change without notice. For pick-up or delivery outside of these areas, please call us for more information.
About Stand-by Generators
Standard Tune-Ups May Include:
Adjust Brakes, Fill Gear Case Fluid, Replace Fuel Filter, Adjust Drive Controls, Inspect Condition of Engine, Replace Spark Plug(s), Change Engine Oil & Filter, Inspect Drive Seals, Test Electrical System, Clean & Adjust Carburetor, Pressure Wash Unit, Test Engine Compression, Clean Cooling Fans, Replace Air Filter, Tighten & Lube Chassis, Clean Fuel System, Test & Run to Ensure Proper Functionality, Go Over Repair & Test Unit with Customer
What’s the difference between stand-by and portable generators?
Stand-by generators are permanently installed appliances, like a compressor for a central air-conditioning system. Its engine runs on natural gas or propane. A portable back-up generator is a small, gas-engine generator that you wheel into position outside the house and plug into the transfer switch. Stand-by units should be sized according to their required wattage use, from essential systems like furnaces and refrigerators to comfort features like lighting and air conditioning.
How do stand-by generators work?
Stand-by generators offer fully automatic operation. They’re connected to an Automatic Transfer Switch (ATS), which is connected to the main electric panel. When utility power is lost, the ATS activates, collects power from the generator, and sends it back to the main panel. When utility power is restored, the ATS automatically shuts off and reverts the power source back to the main electrical panel.
We sell and service portable generators too!
Portable generators are a welcome addition to many activities at home , at work, and away. In an emergency, portable generators can provide critical backup power. They make camping and tailgating more comfortable. And contractors appreciate the flexibility portable power brings to the jobsite.
The East Coast Lumber Equipment Center
is an authorized sales and service dealer for the following manufacturers:
Bob-Cat, Briggs & Stratton, Generac, Giant-Vac, Homelite, Honda, Hydrogear, Kohler, MTD, Poulan, Simplicity, Snapper, Stihl, Subaru/Robin, TimberWolf and TroyBuilt
As an authorized dealer, our factory trained technicians know the ins-and-outs of each equipment model made by these manufacturers. This allows us to perform warranty work without burdening you with lots of paperwork. Bring in your faulty equipment and let us know you what we can do!
Plus, we can repair tools and equipment from other manufacturers, provided the work is not covered under a manufacturer's warranty (*Warranty coverage is only valid when the repair work is performed by either the original manufacturer or an authorized representative). Some of these other manufacturer's include:
AYP, Carlisle, Desa, Oregon and Stanley-Bostitch
Here are just a few of the types of equipment we service and repair:
Air Compressors, Chain Saws, Leaf Blowers, Trimmers, Chain Sharpening, Generators, Heaters (kerosene & propane), Lawn Tractors, Lawn Mowers, Log Splitters, Plate Compactors, Pneumatic Tools & Air Tools, Power Tools (cordless & AC), Power Trowels and Snowblowers
*All equipment and tools brought in for repair are assessed a Repair Estimate Fee (REF). This diagnostic charge is equivalent to 0.5 hours labor. Once diagnostics are complete, a detailed estimate of the repair (including parts & labor) is provided for customer approval before any work begins. Upon approval, items are scheduled for repair and the initial REF will be credited to the repair order. (Customers are required to pay the REF on declined repair orders.)
For the mechanically inclined Do-it-Yourselfer, we stock replacement parts for most power tool and equipment models! Call or email us today!
Annual Generator Tune Up - $250
• Change Oil & Filter (synthetic oil)
• Change (and Gap) Spark Plugs
• Inspection, Lubrication & Adjustments
• Inspect Safety Systems & Battery
• Inspect, Clean & Replace Air Filter (added fee)
• Inspect, Clean & Replace Pre-Cleaner (if applicable)
• Adjust Carburetor
• Hazardous waste disposal
*Additional fees apply for service calls 20+ miles
(round trip) from East Coast Lumber. Covers air-cooled generators up to 22kw. Call for pricing on larger units.
Repair/Service Hourly Rate - $105
Diagnostic testing on your generator plus 5% OFF replacement and repair parts.
*Hourly rate begins when service tech leaves East Coast Lumber.
First Tune-Up Discount*
Take $20 OFF the first stand-by generator tune-up you book with us! |
*Maintenance plans and pricing are subject to change without notice. All plans are only applicable to air-cooled stand-by generators up to 22kW.
**Repair service fees apply for additional service visits, billed at $1 OS/hr with a $1 SO minimum for "Good" and "Better" plans (minimum is waived on "Best" plan .
